Facing issues with your iPad? “why wont my.ipad turn on” is a common question. Are you frustrated because your Ipad won’t turn on? There can be several reasons why an ipad does not turn on. Each has its unique solution. Here’s a walkthrough.
Reasons why my Ipad won’t turn on
Battery depletion:
The battery may be completely drained. Connect the iPad to a power source using the original charging cable and adapter and let it charge for at least 15-30 minutes. Then try turning it on again.
Faulty charger or cable:
The charger or cable you’re using may be defective. Try using a different charging cable and adapter to see if that resolves the issue.
Software crash:
Sometimes, a software crash can prevent the iPad from turning on. To fix this, one can try performing a hard reset. Press and hold both the Sleep/Wake button (or Side button) and the Home button (or Volume Down button on newer models) simultaneously for about 10-15 seconds until the Apple logo is visible. If the device starts up, then the problem is likely a software issue.
Display or hardware issue for why iPad won’t turn on:
It’s possible that there’s a problem with the display or some other hardware component. Check if there are any visible signs of damage or if the device was exposed to water or physical trauma. In such cases, it’s best to contact Apple Support or visit an authorized service center for further assistance.
Power button or charging port problem:
The power button or the charging port might be damaged or malfunctioning. Inspect the charging port for any debris or damage and clean it gently with a soft brush or a dry cotton swab. If there’s a problem with the power button, it may require professional repair.
Methods to fix why iPad won’t turn on
There can be several reasons for iPad not turning on. These are some of the solutions to those possible issues for which my.iPad wont turn on.
Update or restore using iTunes:
Connect the iPad to a computer with iTunes installed. Put it into Recovery Mode by pressing and holding the Sleep/Wake (or Side) button and the Home (or Volume Down) button together until you see the Recovery Mode screen. Then follow the on-screen instructions in iTunes to update or restore your device.
Try a different charging cable and adapter:
Sometimes, the charging cable or adapter may be faulty. Try using a different cable and adapter to see if the iPad charges and turns on.
Perform a DFU (Device Firmware Update) restore:
If the previous methods didn’t work, the user can try a DFU restore. Connect the device to a computer with iTunes. Put your iPad into DFU mode by pressing and holding the Sleep/Wake (or Side) button and the Home (or Volume Down) button together for 8 seconds. After 8 seconds, release the Sleep/Wake (or Side) button while continuing to hold the Home (or Volume Down) button for about 5 seconds. If the screen stays black, you’re in DFU mode. Follow the on-screen instructions in iTunes to perform a restore.
Check for physical damage:
Inspect your iPad for any physical damage, liquid exposure, or loose connections. If you notice any visible damage, it’s best to contact Apple Support or visit an authorized service center for further assistance.
Contact Apple Support for why iPad won’t turn on:
If none of the above methods work, it’s recommended to reach out to Apple Support or visit an authorized service center for professional assistance. They can diagnose the problem and provide appropriate solutions or repairs.
Conclusion
If it is found that the ipad will not turn on despite all these steps, it is recommended to visit any authorised Apple dealer. There can be issues which might require some physical fixing or modification. Moreover, there can be a necessity to replace the iPad.